2014 PROMASTER 3500 3.8L 62te transmission

[joseluis]

After overhaul it drips a little through the front. mainly after running. but not while it is running.
I have replaced the bushing and seal two times with gasquet and pump o ring and still drips after
siting for five minutes after running it has a very slow drip.
I sat for more than 10 minutes watching it while running and no drip till shot off.
I chequed the flywheel, and it has a very mild run-out at the ring gear.
Also any good way to check the level. specs call for 9.5 quarts.
and it wont show on a regular tool.
Thank you all in advance!!

[carod]

Did you replace the convertor?

[joseluis]

Two times.dowel pins seem fine too

[joseluis]

For the final time i pulled the transmission and check the bushing and o ring.all good .and pulled the pump seal out.
the seal was all moist around with ATF.so I replaced the bushing(since it is out )with a sonnax bushing. and remove the glue out of a new seal,and dabbed it around with green lock tite.Installed the transmission back and test drove it for miles.no leaks.customer is out in arizona driving it. to test it right.
No leaks to date. one week and it looks good!

[carod]

Good Job